Reolink produces some of the most reliable 4K dual-band wireless cameras on the consumer market. However, pairing them to third-party Network Video Recorders (NVRs) or Network Attached Storage (NAS) requires specific port activations and ONVIF profile configurations.
Table of Contents
1. Reolink ONVIF Architecture & Port Protocols
Reolink wireless cameras (including the E1 Pro, E1 Zoom, and RLC-series) provide true enterprise-grade ONVIF Profile S and Profile T compliance. By default, Reolink firmware disables certain local network ports for security hardening, which must be manually enabled before third-party NVR synchronization.
Ensure the following port configurations are active under Network → Advanced → Port Settings:
- HTTP / HTTPS Ports: Port 80 / 443 (Used for browser web management).
- RTSP Port: Port 554 (Used for real-time H.264/H.265 transport).
- ONVIF Port: Port 8000 (Required for handshake discovery on Synology, QNAP, and Hikvision NVRs).
2. Adding Reolink Cameras to Standalone NVRs
- Assign a static DHCP reservation to the Reolink camera via your router.
- Log into your NVR administrative dashboard and access Channel Management → Add IP Camera.
- Select protocol ONVIF, enter the camera IP, port
8000, and provide the camera admin credentials. - Set stream encoding to H.264 if your NVR lacks hardware H.265 decompression capability.
Frequently Asked Questions
Reolink locks accounts after 5 failed password attempts. Reboot the camera or wait 15 minutes before re-entering correct credentials.
No. Battery-powered Reolink cameras do not support continuous RTSP/ONVIF streaming to preserve battery chemistry.